A flurry of posts this week which is unusual. There's often lots going on but I don't always get around to posting about them.
Anyway, today I got a stage further with my project to start properly using my two man crosscut saws with the arrival of a jointer/ raker guage which I bought online from America. This one is a 'short' jointer made by Atkins & Co of Indianapolis. It's marked as being patented 'May 5 74' which, the more I think about it, could be 1874? Well, aside from a bit of surface rust, it's in great condition and I'm pleased to see there is still a thin shim of paper under the raker guage plate where the previous user set it up for his saw.
For sharpening, a flat file is clamped into the tool and bent to match the arc of the saw teeth using the screw thread. The file is then run over the teeth to file them all to the same length before they're sharpened. The raker guage sets the distance below this arc of the raker teeth which clear the sawdust from the saw cut. I'm looking forward to trying it out.
There's a lot of interest in two man saws here in the north-west of England and I'm planning to organise a day this year for people to get together and learn about their use, sharpening and maintenance. If you're interested in taking part, send me an email steve-tomlin[@]hotmail.co.uk
Anyway, today I got a stage further with my project to start properly using my two man crosscut saws with the arrival of a jointer/ raker guage which I bought online from America. This one is a 'short' jointer made by Atkins & Co of Indianapolis. It's marked as being patented 'May 5 74' which, the more I think about it, could be 1874? Well, aside from a bit of surface rust, it's in great condition and I'm pleased to see there is still a thin shim of paper under the raker guage plate where the previous user set it up for his saw.
For sharpening, a flat file is clamped into the tool and bent to match the arc of the saw teeth using the screw thread. The file is then run over the teeth to file them all to the same length before they're sharpened. The raker guage sets the distance below this arc of the raker teeth which clear the sawdust from the saw cut. I'm looking forward to trying it out.
There's a lot of interest in two man saws here in the north-west of England and I'm planning to organise a day this year for people to get together and learn about their use, sharpening and maintenance. If you're interested in taking part, send me an email steve-tomlin[@]hotmail.co.uk
Here is the actual URL and a tiny URL to a US Forest Service document on Saws That Sing. If you havn't seen it you will find it helpful. Have fun with your saws
ReplyDeletehttp://www.fhwa.dot.gov/environment/recreational_trails/publications/fs_publications/04232822/lc04232822.cfm
http://tinyurl.com/7eru74r
Thanks Mike,
ReplyDeleteI have read it, also the Crosscut Saw Manual and New Tools for Crosscut Saws
Appreciate you taking the time to comment though.
I've just started to recondition a 5 foot 2 man crosscut and have just read the docs mentioned above. The blade was rusty but little used and I don't think it will need much tuning. I'm not sure what file to get to sharpen the cutting teeth with. Any recommendations?
ReplyDeleteHello Steve; I am Norm Knauf from Muskegon Michigan in the USA. I've had this old device which I did not know what it was but due to your posting I now do & THANK YOU! Mine is exactly like the picture of yours.
ReplyDeleteHey Norm, Glad to be able to help - hope you've got a saw to use it with!
ReplyDelete